HP 2/8q Fibre Channel Network properties

Switch Manager

Network properties

Use the Network Properties dialog box to change the following network settings:

■IP Configuration parameters

■SNMP Configuration parameters

■SNMP Trap Configuration

■Remote Logging parameter

1.Select a switch in the topology display or open the faceplate display.

2.Select Switch > Network Properties. The Network Properties dialog box is displayed (Figure 27).

3.After making changes, click OK to put the new values into effect.

Note: Read Community, Trap Community, and Write Community are similar to passwords and are write-only boxes. Current settings are not displayed.

Figure 27: Network Properties dialog box

IP Configuration parameters

The IP configuration identifies the switch on the Ethernet network and determines which network discovery method to use. Table 15 describes the IP configuration parameters.

72 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide