HP 2/8q Fibre Channel manual Following is an example of the SET Config Threshold command

Command Line Interface

The following is an example of the SET CONFIG THRESHOLD command:

2/8q FC Switch #> admin start

2/8q FC Switch (admin) #> config edit

2/8q FC Switch (admin-config) #> set config threshold

A list of attributes with formatting and current values will follow.

Enter a new value or simply press the ENTER key to accept the current value.

If you wish to terminate this process before reaching the end of the list press 'q' or 'Q' and the ENTER key to do so.

ThresholdMonitoringEnabled	(True / False)	[False	]
CRCErrorsMonitoringEnabled	(True / False)	[True	]
RisingTrigger	(decimal value, 1-1000)	[25	]
FallingTrigger	(decimal value, 0-1000)	[1	]
SampleWindow	(decimal value, 1-1000 sec)	[10	]
DecodeErrorsMonitoringEnabled	(True / False)	[True	]
RisingTrigger	(decimal value, 1-1000)	[200	]
FallingTrigger	(decimal value, 0-1000)	[0	]
SampleWindow	(decimal value, 1-1000 sec)	[10	]
LoginMonitoringEnabled	(True / False)	[True	]
RisingTrigger	(decimal value, 1-1000)	[5	]
FallingTrigger	(decimal value, 0-1000)	[1	]
SampleWindow	(decimal value, 1-1000 sec)	[10	]
LogoutMonitoringEnabled	(True / False)	[True	]
RisingTrigger	(decimal value, 1-1000)	[5	]
FallingTrigger	(decimal value, 0-1000)	[1	]
SampleWindow	(decimal value, 1-1000 sec)	[10	]
LOSMonitoringEnabled	(True / False)	[True	]
RisingTrigger	(decimal value, 1-1000)	[100	]
FallingTrigger	(decimal value, 0-1000)	[5	]
SampleWindow	(decimal value, 1-1000 sec)	[10	]
Finished configuring attributes.
This configuration must be saved (see config save command)		and
activated (see config activate	command) before it can take	effect.

To discard this configuration use the config cancel command.

HP StorageWorks 2/8q Fibre Channel Switch Management User Guide 143