HP 2/8q Fibre Channel manual Set command, Sets a variety of switch parameters

Command Line Interface

Table 49: SNMP configuration default settings (Continued)

Parameter	Default setting
Object ID	1.3.6.1.4.1.1663.1.1.1.1.31
AuthFailureTrap	False
ProxyEnabled	True
Table 50: System configuration default settings
Parameter	Default setting
Ethernet Network Discovery	Static
Ethernet Network IP Address	10.0.0.1
Ethernet Network IP Mask	255.0.0.0
Ethernet Gateway Address	10.0.0.254
Admin Timeout	30 minutes
LocalLogEnabled	True
RemotelogEnabled	False
RemoteLogHostAddress	10.0.0.254
NTPClientEnabled	False
NTPServerAddress	10.0.0.254

Set command

Sets a variety of switch parameters.

Authority

Admin for all keywords except Alarm, Beacon, and Pagebreak.

Syntax

SET

Keywords

ALARM [option]

Controls the display of alarms in the session output stream or clears the alarm log. [option] can be one of the following:

CLEAR—Clears the alarm log history. This value requires an Admin session.

ON—Enables the display of alarms in the session output stream.

OFF—Disables the display of alarms in the session output stream.

BEACON [state]

Enables or disables the flashing of the Logged-In LEDs according to [state]. This keyword does not require an admin session. [state] can be one of the following:

ON—Enables the flashing beacon.

OFF—Disables the flashing beacon.

HP StorageWorks 2/8q Fibre Channel Switch Management User Guide 135