Command Line Interface
Table 57: Show Port parameters (Continued)
Entry | Description |
Link Failures | Number of optical link failures detected by this port. A link |
| failure is a loss of synchronization or a loss of signal while not |
| in the offline state. A loss of signal causes the switch to |
| attempt to |
| a link failure is counted. A link reset is performed after a link |
| failure. |
|
|
Login | Number of device logins |
|
|
Logout | Number of device logouts |
|
|
LoopTimeouts | A two (2) second timeout as specified by |
|
|
LossOfSync | Number of synchronization losses (>100 ms) detected by this |
| port. A loss of synchronization is detected by receipt of an |
| invalid transmission word. |
|
|
PrimSeqErrors | Primitive sequence errors detected. |
|
|
RxLinkResets | Number of link reset primitives received from an attached |
| device. |
|
|
RxOfflineSeq | Number of offline sequences received. An OLS is issued for |
| link initialization, a Receive & Recognize Not_Operational |
| (NOS) state, or to enter the offline state. |
|
|
TotalErrors | Total number of errors detected. |
|
|
TotalLIPsRecvd | Number of loop initialization primitive frames received by this |
| port. |
|
|
TotalLIPsXmitd | Number of loop initialization primitive frames transmitted by |
| this port. |
|
|
TotalLinkResets | Total number of link reset primitives. |
|
|
TotalOfflineSeq | Total number of Offline Sequences issued and received by this |
| port. |
|
|
TotalRxFrames | Total number of frames received by this port. |
|
|
TotalRxWords | Total number of words received by this port. |
|
|
TotalTxFrames | Total number of frames issued by this port. |
|
|
TotalTxWords | Total number of words issued by this port. |
|
|
TxLinkResets | Number of Link Resets issued by this port. |
|
|
TxOfflineSeq | Total number of Offline Sequences issued by this port. |
|
|
post log
Displays the Power On Self Test (POST) log which contains results from the POST.
setup [option]
Displays setup attributes for the system, SNMP, and the switch manufacturer. See the “Show Setup command” on page 166.
steering [domain_id]
Displays the routes that data takes to the switch given by [domain_id]. If you omit [domain_id], the system displays routes for all switches in the fabric.