HP 2/8q Fibre Channel Admin, Admin command

Command Line Interface

Table 44: Commands listed by Authority Level (Continued)

Monitoring commands		Administrative commands
Whoami command	page 173	Reset command	page 131
		Set command	page 135
		Set Config command	page 137
		Set Log Command	page 144
		Set Port command	page 146
		Set Setup command	page 147
		Shutdown command	page 169
		Test command	page 169
		User command	page 171
		Zone Command	page 174
		Zoneset command	page 176

Admin command

Opens and closes an Admin session. The Admin session provides commands that change the fabric and switch configurations. Only one Admin session can be open on the switch at any time. An inactive Admin session times out after a period of time which can be changed using the Set Setup System command. See the “Set Setup command” on page 147.

Authority

Admin

Syntax

ADMIN

Keywords

START

Opens the admin session.

END

Closes the admin session. The Hardreset, Logout, Shutdown, and Reset

Switch commands also end an admin session.

CANCEL

Terminates an Admin session opened by another user. Use this keyword with care because it terminates the Admin session without warning the other user and without saving pending changes.

Notes

Closing a Telnet window during an admin session does not release the session. In this case, you must either wait for the admin session to time out, or use the Admin Cancel command.

HP StorageWorks 2/8q Fibre Channel Switch Management User Guide 117