HP 2/8q Fibre Channel manual Set Config command, Admin and Config Edit

Command Line Interface

Set Config command

Sets switch, port, port threshold alarm, and zoning configuration parameters. The changes you make with this command are not retained when you reset or power cycle the switch unless you save them using the Config Save command. See the “Config command” on page 119.

Authority

Admin and Config Edit

Syntax

SET CONFIG

Keywords

PORT [port_number]

Initiates an edit session in which to change configuration parameters for the port number given by [port_number]. If you omit [port_number], the system begins with port 0 and proceeds in order through the last port. For each parameter, enter a new value or press Enter to accept the current value shown in brackets. Enter q to end the configuration for one port, or qq to end the configuration for all ports. Table 51 describes the port parameters.

PORTS [port_number]

Initiates an editing session in which to change configuration parameters for all ports based on the configuration for the port given by [port_number]. If you omit [port_number], port 0 is used. For each parameter, enter a new value or press Enter to accept the current value shown in brackets. Enter q to end the configuration. Table 51 describes the port parameters.

HP StorageWorks 2/8q Fibre Channel Switch Management User Guide 137