Command Line Interface
Shutdown command
Terminates all data transfers on the switch at convenient points and closes the Telnet session. Always power cycle the switch after entering this command.
Authority
Admin
Syntax
SHUTDOWN
Notes
Always use this command to perform an orderly shut down before removing power from the switch.
When the shutdown is complete, the Heartbeat LED is extinguished.
Test command
Tests ports using internal (SerDes level), external (transceiver), and online loopback tests. Internal and external tests require that the port be placed in diagnostic mode. See the “Set command” on page 135 for information about changing the port administrative state. While the test is running, the remaining ports on the switch remain fully operational.
Authority
Admin
Syntax
TEST
Keywords
PORT [port_number] [test_type]
Tests the port given by [port_number] using the test given by [test_type]. If you omit [test_type], Internal is used. [test_type] can have the following values:
Examples
To run an internal or external port test:
1. To start an admin session, enter the following command:
admin start
HP StorageWorks 2/8q Fibre Channel Switch Management User Guide | 169 |