Item | Values | Explanation |
|
|
|
DHCP settings | DHCP RELEASE |
| *NO |
| YES |
This menu appears if CONFIG METHOD is set to DHCP and a DHCP lease for the print server exists.
NO (default): The current DHCP lease is saved.
YES: The current DHCP lease along with the leased IP address are released.
| DHCP RENEW | This menu appears if CONFIG METHOD is set to DHCP and |
| *NO | a DHCP lease for the print server exists. |
| YES | NO (default): The print server does not request to renew the |
|
| DHCP lease. |
|
| YES: The print server requests to renew the current DHCP |
|
| lease. |
|
|
|
Manual settings | IP ADDRESS | The unique IP address of the printer, where n is a value |
| n.n.n.n | from 0 to 255. |
|
|
|
| SUBNET MASK | The subnet mask for the printer, where m is a value from 0 |
| m.m.m.m | to 255. The mask is applied to IP addresses to uniquely |
|
| identify subnetworks and nodes. |
|
|
|
| SYSLOG SERVER | The IP address of the syslog server used to receive and log |
| n.n.n.n | syslog messages. |
|
|
|
| DEFAULT | The IP address of the gateway or route used for |
| GATEWAY | communications with other networks. |
| n.n.n.n |
|
|
|
|
| IDLE TIMEOUT | The timeout value (in seconds) before an idle TCP print |
| XX | data connection is automatically closed. The default value |
|
| is 270 seconds. 0 disables the timeout. |
|
| |
IPX/SPX | There is no value to select. | |
|
|
|
ENABLE | OFF | Select whether the IPX/SPX protocol stack (in Novell |
| *ON | NetWare networks, for example) is enabled or disabled. |
|
|
|
FRAME TYPE | *AUTO | Select the frame type setting for your network. |
| EN_8023 | AUTO (default): Automatically sets and limits the frame type |
|
| |
| EN_II | to the first one detected. |
|
| |
| EN_SNAP | For an Ethernet network only, frame type selections include |
| TR_8022 | |
| EN_8023, EN_II, EN_8022, and EN_SNAP. | |
| TR_SNAP | |
|
| |
|
| For a Token Ring network only, frame type selections |
|
| include TR_8022 and TR_SNAP. |
|
|
|
SOURCE ROUTING | *AUTO | For a Token Ring network only, specify the NetWare Token |
| OFF | Ring Source Routing parameter. |
| ALL ROUTES | AUTO (default): The type of source routing required on the |
|
| |
| SINGLE ROUTE | network is automatically sensed. |
|
| |
|
| OFF: All packets are sent without source routing, and only |
|
| packets from the same ring are received. |
|
| ALL ROUTES and SINGLE ROUTE: All packets are sent with |
|
| source routing (broadcasts and when the route is |
|
| unknown). |
|
| |
APPLETALK | There is no value to select. | |
|
|
|
ENABLE | OFF | For an Ethernet network only, select whether the AppleTalk |
| *ON | protocol stack is enabled or disabled. |
|
| |
DLC/LLC | There is no value to select. | |
|
|
|
ENABLE | OFF | Select whether the DLC/LLC protocol stack is enabled or |
| *ON | disabled. |
|
|
|
158 B Control panel menus | ENWW |