
Message | Description | Recommended action |
|
|
|
22 EIO [X]
BUFFER OVERFLOW
alternates with
To continue press
Too much data was sent to the EIO card in the specified slot [X]. An improper communications protocol might be in use.
1Press (SELECT button) to clear the message. (The job will not be printed.)
2Check the host configuration. If the message persists, contact an
22 PARALLEL I/O
BUFFER OVERFLOW
alternates with
To continue press
Too much data was sent to the parallel port.
1Check for a loose cable connection and be sure to use a
2This error can occur if the driver you are using is not
3Press (SELECT button) to clear the error message. (The job will not be printed.)
4If the message persists, contact an
22 SERIAL I/O | Too much data was sent to the |
BUFFER OVERFLOW | serial port. |
alternates with |
|
Press (SELECT button) to clear the error message. (The job will not be printed.)
To continue press
22 USB I/O | Too much data was sent to the USB | Press | (SELECT button) to clear |
BUFFER OVERFLOW | port. | the error message. (The job will not | |
|
| be printed.) | |
|
|
|
|
40 EIO [X] BAD | The connection has been broken | Press | (SELECT button) to clear |
TRANSMISSION | between the printer and the EIO | the error message and continue | |
alternates with | card in the specified slot [X]. | printing. |
|
|
|
| |
To continue press |
|
|
|
|
|
|
|
41.X PRINTER ERROR | A temporary printing error occurred. | 1 Press | (SELECT button). The |
alternates with | page containing the error | |
automatically reprints if jam | ||
|
To continue press | recovery is enabled. |
| |
2 | Turn the printer power off, and |
| then turn the printer power on. |
3 | If the message persists, contact |
| an |
| support provider (see |
| |
|
|
92 Chapter 4 Problem solving | ENWW |