To duplex with the
The
1Insert enough paper into one of the trays to accommodate the print job. If you are loading special paper such as letterhead, load it in one of the following ways:
•For tray 1, load the letterhead paper with the first side down, bottom in first.
•For tray 2
CAUTION | Do not load paper that is heavier than 105 g/m2 |
2Open the printer driver (see “Changing the settings for a print job” on page 47).
3On the Finishing tab, select Print on Both Sides.
4Click OK.
5Send the print job to the printer.
Note | The paper you are printing on will partially come out of the top output bin during the duplexing. |
| Do not pull on the paper until duplexing is complete. |
| During duplexing, the duplexer will not function if the rear output bin is open. |
|
|
To duplex manually
1Insert enough paper into one of the trays to accommodate the print job. If you are loading special paper such as letterhead, load it in one of the following ways:
•For tray 1, load the letterhead paper with the first side down, bottom in first.
•For tray 2
2Open the printer driver (see “Changing the settings for a print job” on page 47).
3On the Finishing tab, select Print on Both Sides.
4Click OK.
5Send the print job to the printer.
6Go to the printer. Remove any blank paper from tray 1. Insert the printed stack with the blank side up, top edge in first. You must print the second side from tray 1.
7If prompted by a message at the controil panel display, press 
(SELECT button).
Note | If total sheets exceed the tray 1 capacity for manual duplex jobs, you must repeat steps 6 and 7 |
| each time paper is inserted until the duplexing job is complete. |
|
|
ENWW | Printing on both sides (duplexing) 45 |