6
7
8
9
10
6Remove the DIMM from the antistatic package.
CAUTION
To reduce the possibility of damage caused by static electricity, always wear an electrostatic discharge (ESD) wrist strap or touch the surface of the antistatic package before handling DIMMs.
7Holding the DIMM by the edges (as shown in the illustration), align the notches on the DIMM with the DIMM slot. (Check that the locks on each side of the DIMM slot are open.)
8Press the DIMM straight into the slot (press firmly). Make sure the locks on each side of the DIMM snap inward into place. (To remove a DIMM, the locks must be released.)
Repeat steps 6, 7, and 8 for each DIMM being installed.
9Reconnect the interface cable(s) and power cord.
10To replace the side panel, line up the alignment arrows and slide the panel backwards until the release button latches into place.
11Close the top cover and turn the printer on.
166 Appendix C Printer memory and expansion | ENWW |