HP Designjet 815MFP tell me about the scanner insertion slot

see also

maintenance procedures on page 24

tell me about the scanner insertion slot

You can change the insertion slot height from 2 to 16 mm (0.08 to

0.63inches). The Normal position (Step 0: 2 mm/0.08 in) is detected by a sensor in the scanner.

The insertion slot is marked with a measurement ruler for inches and millimeters. The ruler corresponds to right side aligned original loading. Just below the ruler are marked common standard sizes that help guide you with optional centered loading.

The loading method, right-side or centered, can be selected from your scanner software. The scan area width measured in standard units (inches or millimeters) is also set from the software.

The required setting for an original drawing can be measured with the original inserted into the scanner by using the ruler printed on top of the insertion slot. Then, you just enter your measurement in the width setting box in the current scanner application’s media size setup dialogs. To change the insertion slot height, see how do I change the insertion slot height? on page 8.

hp designjet 815mfp & scanner 4200 59