Converter board

The converter board is located on the left side of the computer (viewed from behind) under the main rear cover. It is secured with two Torx screws and has two connectors.

Use the same converter spare part for all display panels; however, you must change jumper settings on the board based on the display panel.

Figure 6-45Converter board location

To remove the converter board:

1.Prepare the computer for disassembly (see Preparing to disassemble the computer on page 27).

2.Remove the access panel (see Access panel on page 34).

3.Disconnect the two cables from the board (1).

NOTE: Be careful not to damage the cables when disconnecting them from the board. Do not pull on the wires.

58 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis

Page 66
Image 66
HP 8300 C5J37AWABA, 8300 D0K72US#ABA manual 45Converter board location To remove the converter board