HP 9500mfp manual Sending a fax by using speed dial, Then deleted from memory

http://www.hp.com/go/clj9500mfp

4Type a phone number by using the keyboard that appears on the control-panel display.

Note	If a two-second pause is needed, type a comma (,) after a prefix number (such as a “9” or “0”) to allow the
	internal phone system time to reach an outside line before the remainder of the number is dialed.

5To specify additional phone numbers, touch NEXT NUMBER.

Note To remove a number from the list, scroll to and highlight the number and then touch REMOVE.

6Touch START to send the fax. (You can touch START on the touch-screen or press the START button on the control panel.)

Note	When a fax is sent, it is first copied into memory. After the entire document is stored, the fax is sent and is
	then deleted from memory.

Sending a fax by using speed dial

Use the following procedure to send a fax by using speed dial.

Note	Before sending a fax by using speed dial, you must create a speed dial. To create a single speed dial or a
	speed-dial group, see “To create a speed dial” onpage 74.

70 Chapter 4 – Faxing Rev. 1.0