HP 4 C2001A, C2021A, 5n C3952A Fuser Assembly Thermoswitch Removal, Fuser Thermoswitch Connectors

Fuser Assembly Thermoswitch Removal

N o t e	Six of the seven latches are accessed from the top
	of the wire cover. These latches are beneath the
	felt pad. The slot on the front left side of the wire
	harness cover is the best place to begin removing
	the cover.

1 Remove the Wire Harness Cover as shown in Figure 6-42a (LaserJet 4) or Figure 6-42b and c (LaserJet 4 Plus).

2 Remove the (2) screws from the Thermoswitch connector (see Figure 6-46, callout 1).

3 Release the thermoswitch latch from the paper sensor flag side of the Fuser Assembly (behind the side cover). (See Figure 6-46, callout 2).

4 Slide the Thermoswitch to the gear side of the fuser and release it from the fuser frame (callout 3).

Figure 1-46 Fuser Thermoswitch Connectors

6-55 Removal and Replacement