![](/images/new-backgrounds/1113905/11390539x1.webp)
Thermal/Mechanical Reference Design
processor operating frequency (via the bus multiplier) and input voltage (via the VID signals). Please refer to the
PROCHOT# is designed to assert at or a few degrees higher than maximum TCASE (as specified by the thermal profile) when dissipating TDP power, and can not be
interpreted as an indication of processor case temperature. This temperature delta accounts for processor package, lifetime, and manufacturing variations and attempts to ensure the Thermal Control Circuit is not activated below maximum TCASE when dissipating TDP power. There is no defined or fixed correlation between the PROCHOT# assertion temperature and the case temperature. However, with the introduction of the Digital Thermal Sensor (DTS) on the
By taking advantage of the Thermal Monitor features, system designers may reduce thermal solution cost by designing to the Thermal Design Power (TDP) instead of maximum power. TDP should be used for processor thermal solution design targets. TDP is not the maximum power that the processor can dissipate. TDP is based on measurements of processor power consumption while running various high power applications. This data set is used to determine those applications that are interesting from a power perspective. These applications are then evaluated in a controlled thermal environment to determine their sensitivity to activation of the thermal control circuit. This data set is then used to derive the TDP targets published in the processors datasheet. The Thermal Monitor can protect the processors in rare workload excursions above TDP. Therefore, thermal solutions should be designed to dissipate this target power level. The thermal management logic and thermal monitor features are discussed in extensive detail in the
In addition,
2.2.2Digital Thermal Sensor
The
The DTS facilitates the use of multiple thermal sensors within the processor without the burden of increasing the number of thermal sensor signal pins on the processor package. Operation of multiple DTS will be discussed in more detail in Section 2.2.4. Also, the DTS utilizes thermal sensors that are optimally located when compared with thermal diodes available with legacy processors. This is achieved as a result of a
20 |
|