Invacare M61, M50, M51 service manual Wheelchair Operation, Turning the Power On/Off

SECTION 4—WHEELCHAIR OPERATION

SECTION 4—WHEELCHAIR

OPERATION

WARNING

After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Set-up of the Electronic Control Unit is to be performed only by a qualified technician. The final adjustments of the controller may affect other activities of the wheelchair. Damage to the equipment could occur if improperly set-up or adjusted.

Turning the Power On/Off

M50 and M51 Wheelchairs Manufactured Before 8/15/05

NOTE: For this procedure, refer to FIGURE 4.1.

1.Turn the power On by moving the On/Off switch up or down. The switch automatically retracts back to center position.

NOTE: After turning power On, all indicators will light briefly and the display gauge will

Information

indicate one of the following:

Gauge

• The Current Battery Charge -

INVACARE

Information gauge shows all LEDs lit or partial LEDs lit. Refer to table in Information Gauge Display on page 40.

•Out Of Neutral At Power Up - Information Gauge shows all LEDs flashing slowly. This occurs when the power is turned On when the joystick is out of neutral. This feature prevents sudden and unexpected movements of the power chair.

2.Turning the power Off can be achieved by moving the On/Off switch up or

down. The switch automatically	ON/OFF
retracts back to center position.	Toggle Switch

FIGURE 4.1 Turning the Power On/Off -

M50 and M51 Wheelchairs Manufactured

Before 8/15/05

Pronto® Series 32 Part No. 1125075