SECTION 10—SHROUDS AND FRAME

Installing

1.If necessary, insert one bushing into each end of the pivot tube.

2.Position the pivot tube onto the pivot post.

NOTE: Ensure the opposite end of the pivot tube is parallel to the end of the walking beam. If necessary, reposition the pivot tube.

3.Secure the end of the pivot tube to the pivot post using the two small washers, the large washer and the locknut. Torque to 90 in-lbs ± 20%.

4.Install the front headtube assembly. Refer to Removing/Installing the Front Headtube Assembly on page 83.

Small Washers

Locknut

Walking Beam

Pivot Post

Large Washer

Pivot Tube

Bushings

FIGURE 10.5 Removing/Installing the Pivot Tube

Pronto® Series

92

Part No. 1125075

Page 92
Image 92
Invacare M61, M50, M51 service manual Removing/Installing the Pivot Tube