SECTION 7—ASBA SEAT
2.On the side of wheelchair with armrest removed, remove one of the mounting screws, washer, coved washer and locknut that secures the back cane to the seat frame.
3.Cut the
4.Thread the mounting screw removed in STEP 2 through the back cane from the inside of the wheelchair to hold the insert in place.
5.Remove the remaining mounting screw, washer, coved washer and locknut that secures the back cane to the seat frame.
6.Repeat STEPS
7.Remove the two mounting screws and washers that secure the existing back upholstery to the back canes.
8.If present, release hook and loop strap securing the back upholstery to the back canes.
9.Remove the two mounting screws used to keep inserts in the back canes in STEP 3. Set mounting screws and inserts aside.
10.Loosen, but DO NOT remove, the two mounting screws and locknuts securing the spreader bar to the back canes.
11.Grasp the hand grip and slide the back cane out of the spreader bar (if applicable) and the back upholstery.
Installing
NOTE: If replacing back upholstery, discard existing back upholstery and perform this procedure using new back upholstery.
NOTE: If replacing back canes, discard existing back canes and perform this procedure using new back canes.
NOTE: Spreader bar is required on ALL back heights between
1.Slide one back cane into back upholstery and through spreader bar (if applicable).
2.Position insert into bottom of back cane.
3.From inside of wheelchair, thread a mounting screw through the back cane to hold the insert in position when installing the back assembly.
4.Repeat STEPS
NOTE: If changing the back angle, refer to Adjusting the Back Angle on page 71 to determine the proper mounting holes for the desired back angle.
5.Position back assembly between the back angle plates (FIGURE 7.8).
6.On one side of wheelchair, align back cane mounting holes with the desired mounting holes of the back angle plate.
Pronto® Series | 68 | Part No. 1125075 |
