
SECTION 7—ASBA SEAT
M61 Wheelchairs
NOTE: For this procedure, refer to FIGURE 7.3 on page 63.
NOTE: The seat comes installed with two sets of two
1.Remove the seat. Refer to Removing/Installing the Seat Assembly on page 59.
2.Remove the four mounting screws, washers, and locknuts securing the seat pivot and four
3.Perform one of the following:
•To Reduce Seat Height by 1 Inch - Remove one set of
•To Reduce Seat Height by 2 Inches - Remove both sets of
4.Perform one of the following:
NOTE: The seat comes installed with four spacers secured by
•For Seat Height Reduced by 1 Inch -
i.Align the mounting holes on the seat pivot with the mounting holes on the adjustment spacers and the seat frame plate.
ii.Install the seat adapter to seat frame plate using the
•For Seat Height Reduced by 2 Inches -
i.Align the mounting holes on the seat pivot with the mounting holes on the adjustment spacers and the seat frame plate.
ii.Install the seat adapter to seat frame plate using the
5.Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 59.
Pronto® Series | 62 | Part No. 1125075 |