SECTION 8—FRONT RIGGINGS/FOOTBOARD
4.Using the two socket bolts, spacers and locknuts, secure the telescoping front rigging support to the seat frame.
5.If necessary, repeat STEPS
6.Reinstall the seat assembly. Refer to Removing/Installing the Seat Assembly on page 50.
|
| Mounting | |
|
|
| Bolts |
Seat |
|
| Telescoping Front |
|
|
| |
|
|
| Rigging Support |
|
|
| Hinge |
|
|
| Pins |
Locknuts | 8 |
|
|
Spacers |
|
| |
7 | 6 |
| |
Inner |
| 5 | 3 |
Mounting |
| ||
| 4 | Not Used | |
|
| ||
Holes |
|
| 2 |
Mounting Holes
FRONT RIGGING | STANDARD | 1 INCH OUT | 2 INCHES OUT | |
MODEL | POSITION |
|
| |
|
|
|
| |
PHW93 | Holes | Holes | Holes | |
4 and 5 | 5 and 6 | 6 and 7 | ||
| ||||
|
|
|
| |
PH904A and PHAL4A | Holes | Holes | Holes | |
3 and 4 | 4 and 5 | 5 and 6 | ||
| ||||
|
|
|
|
FIGURE 8.6 Adjusting/Replacing Telescoping Front Rigging Supports
ASBA Seat
NOTE: For this procedure, refer to FIGURE 8.7 on page 78.
1.Remove the two mounting screws, spacers and locknuts that secure the telescoping front rigging support to the seat frame.
2.Perform one of the following:
•Slide existing telescoping front rigging support to one of three depth positions.
•Remove existing telescoping front rigging.
Part No. 1125075 | 77 | Pronto® Series |
