SECTION
SYMPTOM | PROBABLE CAUSE | SOLUTIONS | |
|
|
| |
| Consumer not charging batteries long | Instruct consumer to charge for | |
| enough. | minimum. | |
Batteries have |
|
| |
Batteries may be weak. | Perform load test or check “Battery Quality Menu” | ||
short driving range | |||
| with the programmer. Refer to electronics manual. | ||
during a single |
| ||
| Refer to Field Load Test on page 30. | ||
charge. Battery |
| ||
|
| ||
Check programming settings. | Torque setting and power level setting may be too | ||
Gauge falls off | |||
| high. Refer to electronics manual. | ||
faster than normal. |
| ||
|
| ||
| Heavy load on motors. | Chairs weight distribution may be offset | |
|
| (wheelchair may be front loaded). | |
|
|
|
M61 Only
SYMPTOM | PROBABLE CAUSE | SOLUTIONS |
|
|
|
Wheelchair slows | Elevating seat is elevated. | Return seat to its lowest position. Refer to |
or stops while |
| Elevating the Seat on page 37. |
driving and the Seat |
|
|
Function I indicator |
|
|
is lit. |
|
|
|
|
|
| Elevating seat sensor is damaged. | Examine elevating seat sensor. Replace if necessary. |
|
| Refer to Removing/Installing the Actuator Switch |
|
| Sensor on page 97. |
|
|
|
Checking Battery Charge Level
The following “Do’s” and “Don’ts” are provided for your convenience and safety.
DO | DON’T |
|
|
Read and understand this manual and any service | Don’t perform any installation or maintenance without |
information that accompanies a battery and charger | first reading this manual. |
before operating the wheelchair. |
|
|
|
Move the wheelchair to a work area before opening | Don’t perform installation or maintenance of batteries |
battery box or installing service batteries. | in an area that could be damaged by battery spills. |
|
|
Recharge as frequently as possible to maintain a high | Don’t make it a habit to discharge batteries to the |
charge level and extend battery life. | lowest level. |
|
|
Follow recommendations in this manual when | Don’t use randomly chosen batteries or chargers. |
selecting a battery or charger. |
|
|
|
Fully charge new batteries before using. | Don’t put new batteries into servcie before charging. |
|
|
Use a carrying strap to remove, move or install a | Don’t tip or tilt batteries. |
battery. |
|
|
|
Push battery clamps on the terminals. Spread clamps | Don’t tap on clamps and terminals with tools. |
wider if necessary. |
|
|
|
Use ONLY a GEL charger for a GEL battery or | Don’t mismatch your battery and chargers. |
“Sealed” battery. |
|
|
|
Part No. 1125075 | 29 | Pronto® Series |
