Invacare M50, M51 SPJJoystick Switches and Indicators, On/Off Toggle Switch, Speed Control Knob

SECTION 4—WHEELCHAIR OPERATION

SPJ™Joystick Switches and Indicators

NOTE: For the following information, refer to FIGURE 4.9.

NOTE: The SPJ joystick is used on M50 and M51 wheelchairs manufactured before 8/15/05 only.

Joystick	Charger/Programmi
	ng Input

Speed Control Knob

On/Off

Toggle Switch

To Controller

FIGURE 4.9 SPJ™Joystick Switches and Indicators

On/Off Toggle Switch

This toggle switch is located at the back of the joystick housing.

Speed Control Knob

The speed control knob is located on the back of the joystick housing. This rotary switch is used for controlling the speed and acceleration of the wheelchair.

1.Turn the switch clockwise to increase the speed of the wheelchair.

2.Turn the switch counterclockwise to decrease the speed of the wheelchair.

Joystick

The joystick has proportional drive control, meaning that further the wheelchair is pushed from the upright (neutral) position, the faster it moves. Your top speed, however, is limited by the setting of the speed-control knob and programmed settings.

To slow the wheelchair to a stop, simply release the joystick. The wheelchair has automatic speed and direction compensation to minimize corrections.

Charger/Programming Input

Located at the front of the joystick housing. This provides easy access for charging the wheelchair batteries. This port also serves as the Remote Programmer Communication connection.

Part No. 1125075 39 Pronto® Series