SECTION 9—WHEELS

Removing/Installing the Drive Wheel

NOTE: For this procedure, refer to FIGURE 9.4 on page 85.

Removing the Drive Wheel

1.Fold down tab of existing locking tab washer (Detail “A” of FIGURE 9.4).

2.Remove mounting bolt and locking tab washer (Detail “B” of FIGURE 9.4). Discard existing locking tab washer.

3.Remove the wheel from the drive shaft. If necessary, use wheel puller to remove the drive wheel from the drive shaft.

Installing the Drive Wheel

NOTE: Ensure keystock is in the cutout on the drive shaft (Detail “B” of FIGURE 9.4). The keystock MUST line up with the wheel hub cutout.

CAUTION

DO NOT apply more than a one-inch (in length) thin film of anti-seize compound to the drive shaft. Applying more than one-inch (in length) can cause the anti-seize compound to leak resulting in damage to flooring (carpet, tile, etc.).

1.Apply an anti-seize compound to drive shaft and keystock.

2.Align the keystock in the drive shaft with the cutout in the wheel hub and position the wheel on to the drive shaft (Detail “B” of FIGURE 9.4).

WARNING

Failure to properly install locking tab washer can result in wheel separation and potential user injury or property damage. When replacing wheels ALWAYS use a new locking tab washer. DO NOT reuse locking tab washers.

NOTE: The locking tab of the locking tab washer MUST be inserted into the cutout in the rim and hub (Detail “B” of FIGURE 9.4).

3.Using the mounting bolt, washer and new locking tab washer, secure the wheel to the drive shaft (Detail “B” of FIGURE 9.4).

4.Fold one tab of the locking tab washer up so that the tab rests against one side of the mounting bolt (Detail “A” of FIGURE 9.4)

Pronto® Series

84

Part No. 1125075

Page 84
Image 84
Invacare M50, M51, M61 service manual Removing/Installing the Drive Wheel, Removing the Drive Wheel