SECTION 7—ASBA SEAT
Mounting
Screw
Rear of Seat | Seat Pan |
|
Frame
Seat Positioning Strap
Front of Seat
Frame
Quick Release Pin Tab |
|
| Spacer |
| |||
|
|
| |
| Seat Rail | Locknut | |
FIGURE 7.7 Removing/Installing the Seat Positioning Strap
Removing/Installing the Back Upholstery
NOTE: The back canes MUST be removed when removing/installing the back upholstery. Refer to Removing/Installing/Changing the Back Cane Height on page 67.
Removing/Installing/Changing the Back Cane Height
NOTE: For this procedure, refer to FIGURE 7.8 on page 70.
NOTE: If changing the back height, new back upholstery may be needed as well. Refer to the following chart to determine if new back upholstery is needed:
NOTE | BACK UPHOLSTERY | |
| HEIGHT | |
|
| |
If back height required is within the range of the original back upholstery | 16 to 17 inches | |
height, only new back canes will be needed. |
| |
18 to 19 Inches | ||
| ||
|
| |
If the back height required is NOT within the range of the original back uphol- | 20 inches | |
stery height, new back upholstery, and back canes will be required |
| |
21 to 22 inches | ||
| ||
|
|
NOTE: Existing hardware and inserts will be reused.
NOTE: Take note of position and orientation of mounting hardware for reinstallation.
Removing
1.Remove flip back armrest from the wheelchair. Refer to Removing/Installing Flip Back Armrest on page 47.
NOTE: Note the back angle before disassembly for proper reinstallation.
Part No. 1125075 | 67 | Pronto® Series |
