Juniper Networks J2320 manual Using the J-Web Interface, Starting the J-Web Interface

Chapter 4: Services Router User Interface Overview

Using the J-Web Interface

This section contains the following topics:

■Starting the J-Web Interface on page 81

■J-Web Layout on page 82

■Elements of the J-Web Interface on page 83

■Navigating the J-Web Interface on page 85

■J-Web Sessions on page 88

For more information about using the J-Web interface, see the J-Web Interface User Guide.

Starting the J-Web Interface

To start the J-Web interface:

1.Launch your HTTP-enabled or HTTPS-enabled Web browser.

To use HTTPS, you must have installed a certificate on the Services Router and enabled HTTPS.

NOTE: If the Services Router is running the worldwide version of the JUNOS Internet software and you are using the Microsoft Internet Explorer Web browser, you must disable the Use SSL 3.0 option in the Web browser to access the Services Router.

2.After http:// or https:// in your Web browser, type the hostname or IP address of the Services Router and press Enter.

The J-Web login page appears.

3.On the login page, type your username and password, and click Log In.

To correct or change the username or password you typed, click Reset, type the new entry or entries, and click Log In.

NOTE: The default username is root with no password. You must change this during initial configuration or the system does not accept the configuration.

The J-WebQuick Configuration>Set Up or Monitor>System page appears.

To explicitly terminate a J-Web session at any time, click Logout in the top pane.

Using the J-Web Interface ■ 81