Juniper Networks J2320 manual J4350 and J6350 Field-Replaceable PIM Summary

Chapter 3: PIM and VoIP Module Overview

NOTE: Although J2320 and J2350 Services Routers support PIMs that were introduced before the JUNOS 8.4 release, these routers do not support software releases earlier than JUNOS 8.4.

Table 19: J2320 and J2350 Field-Replaceable PIM Summary

				Sample Interface Name
	Supported Software Releases
PIM	for This PIM	Port Numbering		(type-pim/0/port)
1-Port SFP, 6-Port SFP,	JUNOS 8.4 and later	Ports:		ge-2/0/0
8-Port, and 16-Port		■	0
Gigabit Ethernet uPIMs
			0 through 5
		■
		■	0 through 7
		■	0 through 15
Dual-Port Serial PIM	JUNOS 8.4 and later	Ports—0 and 1		se-3/0/1
Dual-Port T1 or E1 PIM	JUNOS 8.4 and later	Ports—0 and 1		t1-0/0/1
				or
				e1-0/0/1
Dual-Port Channelized	JUNOS 8.4 and later	Ports—0 and 1		ct1-0/0/0
T1/E1/ISDN PRI PIM
				ce1-0/0/0
4-Port ISDN BRI PIM	JUNOS 8.4 and later	Ports—0, 1, 2, and 3		br-1/0/2
ADSL PIM	JUNOS 8.4 and later	Port—0		at-2/0/0
G.SHDSL PIM	JUNOS 8.4 and later	Ports—0 and 1		at-1/0/0

J4350 and J6350 Field-Replaceable PIM Summary

Table 20 on page 48 provides software release information, slot and port numbers, and sample interface names for the field-replaceable PIMs supported on J4350, and J6350 Services Routers.

CAUTION: Do not install a combination of PIMs in a single chassis that exceeds the maximum power and heat capacity of the chassis. If J-series power management is enabled, PIMs that exceed the maximum power and heat capacity remain offline when the chassis is powered on.

To verify that the combination of PIMs to be installed in a chassis does not exceed the power and heat capacities for the J4350 or J6350 router, see “Planning for Power Management” on page 110.

Field-Replaceable PIMs ■ 47