Chapter 10: Replacing Hardware Components

Figure 87: J4350 and J6350 DRAM Location

To modify the DRAM configuration, use the following procedures:

Removing a DRAM Module on page 191

Installing a DRAM Module on page 192

Removing a DRAM Module

To remove a DRAM module:

1.Place an electrostatic bag or antistatic mat on a flat, stable surface.

2.Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the router is disconnected from earth ground. For more information about ESD, see the Getting Started Guide for your router.

3.Press and release the power button to power off the router. Wait for the POWER LED to turn off.

4.Unplug the power cord or cable from the power source receptacle.

5.Remove the screws from the sides and top of the chassis that secure the cover to the chassis.

6.Slide the cover off the chassis. (For J2320 and J2350 routers, see “Removing and Replacing the Chassis Cover on J2320 and J2350 Routers” on page 178.)

7.To release the DRAM module, press the plastic ejectors on both sides of the module (see Figure 88 on page 192).

8.Grasp the DRAM module, being careful not to touch any electrical components on the module, and firmly pull it out of the slot on the system board.

9.Place the DRAM module on the antistatic mat or in the electrostatic bag.

Replacing DRAM Modules 191

Page 213
Image 213
Juniper Networks J2320 manual Removing a Dram Module, J4350 and J6350 Dram Location