Juniper Networks J2320 Planning for Power Management, Name Model Number, Tokens Junos CLI Power

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide

Planning for Power Management

Before you install a chassis or add a new PIM to an existing chassis, verify that the combination of PIMs to be installed does not exceed the power and heat capacities for that model. Add the power and heat tokens required by each PIM, and compare them to the capacity of the chassis.

CAUTION: Do not install a combination of PIMs in a single chassis that exceeds the maximum power and heat capacity of the chassis. If J-series power management is enabled, PIMs that exceed the maximum power and heat capacity remain offline when the chassis is powered on.

To verify that the combination of PIMs to be installed in a chassis does not exceed the power and heat capacities for that model:

1.Check Table 51 on page 110 to determine the token values for power and heat for each PIM that you plan to install in the chassis.

2.Add the power tokens and heat dissipation tokens for all PIM to be installed in the chassis.

3.Verify that the total number of power tokens and the total number of heat dissipation tokens do not exceed the maximums permitted for your J-series chassis as specified in Table 52 on page 112.

Table 51 on page 110 shows the power consumption and heat dissipation, represented in non-dimensional tokens, assigned to each J-series PIM.

Table 51: J-series PIM Power Consumption and Heat Dissipation

Name	Model Number	PIM Abbreviation	Tokens
		in JUNOS CLI	Power	Heat
1-Port Gigabit	JXU-SFP-S	1xSFP uPIM	8	8
Ethernet uPIM
6-Port Gigabit	JXU-6GE-SFP-S	6xSFP uPIM	13	13
Ethernet uPIM
8-Port Gigabit	JXU-8GE-TX-S	8xGE uPIM	21	27
Ethernet uPIM
16-Port Gigabit	JXU-16GE-TX-S	16xGE uPIM	38	36
Ethernet uPIM
1-Port Copper	JXE-1GE-TX-S	1xGE Copper	6	7
Gigabit Ethernet
ePIM
1-Port SFP Gigabit	JXE-1GE-SFP-S	1xGE SFP	4	4
Ethernet ePIM
Dual-Port Serial	JX-2Serial-S	2xSerial	5	6
PIM

110■ Power Guidelines, Requirements, and Specifications