Juniper Networks manual J2320 and J2350 Avaya VoIP Module Summary, Sample Interface, Vp-3/0/0

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide

CAUTION: Do not install a combination of PIMs in a single chassis that exceeds the maximum power and heat capacity of the chassis. If J-series power management is enabled, PIMs that exceed the maximum power and heat capacity remain offline when the chassis is powered on.

On each J-series Services Router with Avaya VoIP, a single TGM550 Telephony

Gateway Module (TGM) and at least one telephony interface module (TIM) is required.

No more than four TIMs of any kind can be installed on a single chassis.

Table 34: J2320 and J2350 Avaya VoIP Module Summary

							Sample Interface
							Name
			Software Release for	Slot and Port		Maximum Number on
PIM	Also Called		This PIM	Numbering		a Chassis	(type-pim/0/port)
TGM550	■	TGM550	JUNOS 8.4 and later	■	J2320—Slots	One (required)	vp-3/0/0
Telephony		Gateway			1 through 3
Gateway		Module		■	J2350—Slots	If more than one	(See the interface
Module	■	TGM550			1 through 5	TGM550 is installed,	naming conventions
						only the one in the	in the J-series Services
						lowest-numbered slot	Router Basic LAN and
						is enabled. For	WAN Access
						example, if TGM550s	Configuration Guide.)
						are installed in slots 2
						and 3, only the one in
						slot 2 is enabled.
TIM510 E1/T1	■	TIM510	JUNOS 8.4 and later	■	J2320—Slots	Two	–
Telephony		E1/T1 media			1 through 3
Interface		module		■	J2350—Slots
Module
	■	TIM510			1 through 5
TIM514	■	TIM514	JUNOS 8.4 and later	■	J2320—Slots	Two	–
Analog		analog media			1 through 3
Telephony		module		■	J2350—Slots
Interface
	■	TIM514			1 through 5
Module
TIM521 BRI	■	TIM521 BRI	JUNOS 8.4 and later	■	J2320—Slots	Two	–
Telephony		media			1 through 3
Interface		module		■	J2350—Slots
Module
	■	TIM521			1 through 5

68■ Avaya VoIP Modules