Juniper Networks J2320 manual Installing and Connecting a Services Router, Before You Begin

Chapter 6

Installing and Connecting a Services Router

Make the appropriate preparations and verify the J-series equipment before installing a J-series Services Router and connecting it to a power source and the network.

CAUTION: Do not install a combination of PIMs in a single chassis that exceeds the maximum power and heat capacity of the chassis. If J-series power management is enabled, PIMs that exceed the maximum power and heat capacity remain offline when the chassis is powered on.

This chapter contains the following topics:

■Before You Begin on page 115

■Unpacking a J-series Services Router on page 116

■Installing J2320 and J2350 Routers on page 117

■Installing J4350 and J6350 Routers on page 118

■Connecting Interface Cables to Services Routers on page 121

■Chassis Grounding on page 121

■Connecting Power on page 122

■Powering a Services Router On and Off on page 127

Before You Begin

Before you begin installation, complete the following tasks:

■Read the information in “Maintenance and Operational Safety Guidelines and Warnings” on page 273, with particular attention to “Chassis Lifting Guidelines” on page 263.

■Determine where to install the Services Router, and verify that the rack or installation site meets the requirements described in “Preparing for Router Installation” on page 101.

■For installation, gather the following equipment and tools:

Before You Begin ■ 115