Juniper Networks J2320 manual Replacing Dram Modules

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide

3.Insert the USB storage device into the USB port. If the USB storage device does not easily slide into the port, it might not be oriented correctly. Turn the USB storage device upside-down and try again.

4.To configure the USB storage device with the request system snapshot command, see the J-series Services Router Administration Guide.

Replacing DRAM Modules

The DRAM installed on the Routing Engine provides storage for the routing and forwarding tables and for other Routing Engine processes. The design of the Routing Engine allows you to modify the DRAM configuration by adding DRAM modules to the system board, or removing DRAM modules from the board.

The DRAM modules are located on the top of the system board, as shown in Figure 86 on page 190 and Figure 87 on page 191. Two pairs of slots are available for installing DRAM modules. Installing DRAM modules in slots away from each other provides better performance than installing them in two adjacent slots.

NOTE: Use only DRAM modules purchased through Juniper Networks specifically for your model.

Figure 86: J2320 and J2350 DRAM Location

190■ Replacing DRAM Modules