Juniper Networks J2320 manual PIM and VoIP Module Overview

Chapter 3

PIM and VoIP Module Overview

J-series Services Routers accept Physical Interface Modules (PIMs) and Avaya VoIP modules in the slots on the front of the chassis.

CAUTION: PIMs and VoIP modules are not hot-swappable. You must power off the Services Router before removing or inserting a PIM or VoIP module. Ensure that the PIMs and VoIP modules are installed in the router chassis before booting up the system.

A Physical Interface Module (PIM) is a network interface card that is installed on a J-series Services Router, to provide physical connections to a LAN or a WAN. The PIM receives incoming packets from the network and transmits outgoing packets to the network. Each PIM is equipped with a dedicated network processor that forwards incoming data packets to the Routing Engine, and receives outgoing data packets from the Routing Engine. During this process, the PIM performs framing and line-speed signaling for its medium type.

For a complete list of supported PIMs, see “Field-Replaceable PIMs” on page 46.

Avaya VoIP modules are installed in the router chassis like PIMs, but are controlled by the Avaya Communication Manager (CM) software rather than the JUNOS Internet software. For a complete list of supported modules, see “Avaya VoIP

Modules” on page 67.

For J-series Services Router PIM compatibility matrix and datasheets, go to

http://www.juniper.net/products/jseries/.

For information about network interfaces, and for configuration instructions, see the J-series Services Router Basic LAN and WAN Access Configuration Guide.

This chapter contains the following topics:

■PIM and VoIP Module Terms on page 44

■Field-Replaceable PIMs on page 46

■Avaya VoIP Modules on page 67

■43