Juniper Networks J2320 manual Connecting to a Services Router, Connecting to the J-Web Interface

Chapter 7: Establishing Basic Connectivity

■An Ethernet cable (provided)

■If you are performing the initial configuration with the CLI, collect the following equipment:

■A management device, such as a PC or laptop, with a serial port and an asynchronous terminal application (such as Microsoft Windows Hyperterminal)

■An RJ-45 to DB-9 serial port adapter (provided)

■An Ethernet cable (provided)

■For a remote connection, two dial-up modems

■For a remote modem connection, a DB-9 female to DB-25 male adapter, or other adapter appropriate for your modem (not provided)

Connecting to a Services Router

You can connect to the Services Router using the J-Web or CLI interface.

This section contains the following topics:

■Connecting to the J-Web Interface on page 135

■Connecting to the CLI Locally on page 137

■Connecting to the CLI Remotely on page 139

Connecting to the J-Web Interface

If you plan to use the J-Web interface to configure the Services Router, you must connect through one of the built-in Ethernet management ports, as shown in Figure 64 on page 136 and Figure 65 on page 137.

When the Services Router is powered on for the first time, the system looks for a DHCP server, and if it does not find one, it assigns an IP address within the 192.168.1.0/24 subnetwork to any devices connected to it.

To connect to the J-Web interface through port 0 on the router (see Figure 64 on page

136 and Figure 65 on page 137):

1.On the management device, such as a PC or laptop, you use to access the J-Web interface, verify that the address of the port that you connect to the router is set to one of the following:

■An Ethernet address on the 192.168.1/24 subnetwork other than

192.168.1.1

■An Ethernet address from a DHCP server

2.Turn off the power to the management device.

3.Plug one end of the Ethernet cable into the Ethernet port on the management device.

Connecting to a Services Router ■ 135