Juniper Networks J2320 manual Installing an AC Power Supply in J6350 Routers

Chapter 10: Replacing Hardware Components

NOTE: If the power supply is a redundant power supply in a J6350 Service Router, you can leave the router powered on and power flowing in the other power supply.

3.Unplug the power cord from the power source receptacle.

4.Unplug the power cord from the appliance inlet on the power supply faceplate.

5.Slide the ejector tab on the power supply faceplate to the right and hold it in place to unlock the power supply.

6.Grasp the handle on the power supply faceplate, and pull firmly to start removing the power supply. Slide it halfway out of the chassis (see Figure 89 on page 195).

7.Place one hand underneath the power supply to support it and slide it completely out of the chassis.

8.If you are not reinstalling a power supply into the emptied slot, install a blank power supply panel over the slot.

Figure 89: Removing an AC Power Supply

Installing an AC Power Supply in J6350 Routers

To install an AC power supply in a J6350 Services Router (see Figure 90 on page 196):

1.Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the router is disconnected from earth ground. For more information about ESD, see “Preventing Electrostatic Discharge Damage” on page 249.

2.Using both hands, slide the power supply into the chassis until you feel resistance.

3.Firmly push the power supply into the chassis until it comes to a stop. Make sure that the power supply faceplate is flush with any adjacent power supply faceplate.

4.Insert the appliance coupler end of a power cord into the appliance inlet on the power supply faceplate.

5.Insert the power cord plug into an AC power source receptacle.

Replacing Power System Components ■ 195