Juniper Networks J2320 Connecting to the CLI Remotely, Configuring the Modem at the Router End

Chapter 7: Establishing Basic Connectivity

Figure 67: Connecting to the Console Port on J4350 and J6350 Routers

Connecting to the CLI Remotely

You can connect to the CLI from a remote location through two dial-up modems: a modem that is connected to the console port on the Services Router and a second modem connected to a remote management device. The modem connection allows you to remotely perform the same console operations you can perform locally.

This section contains the following topics:

■Configuring the Modem at the Router End on page 139

■Connecting the Modem to the Console Port on page 140

■Connecting to the CLI at the User End on page 141

Configuring the Modem at the Router End

NOTE: These instructions use Hayes-compatible modem commands to configure the modem. If your modem is not Hayes-compatible, refer to the documentation for your modem and enter equivalent modem commands.

Before you can connect a dial-up modem to the console port on the Services Router, you must configure the modem to accept a call on the first ring and accept Data Terminal Ready (DTR) signals. You must also disable flow control on the modem.

To configure the modem on the router end:

1.Connect the modem to a PC or laptop computer.

2.Power on the modem.

Connecting to a Services Router ■ 139