JUNOS Software with Enhanced Services Hardware Guide

Table 46: Tools and Parts Required

Tool or Part

Electrostatic bag or antistatic mat

Electrostatic discharge (ESD) grounding wrist strap

Flat-blade screw-blade screwdriver, approximately 1/4 in. (6 mm)

Phillips (+) screwdriver, number 1 and number 2

Components

All

All

PIM

Chassis cover

Compact flash

Crypto Accelerator Module

DRAM modules

PIM

Power system components

Replacing the Console Port Cable

The RJ-45 port labeled CONSOLE on the Services Router's front panel allows you to connect the router to an external management device, such as a laptop or a terminal server. For cable specifications, see “Chassis Console Port Pinouts” on page 190.

To replace the console port cable:

1.Locate an appropriate replacement cable and connector.

2.Plug the Ethernet connector at either end of the cable into the console port on the front panel (see Figure 57 on page 100).

3.Plug the connector at the other end of the cable into the external management device. If you are connecting to a DB-9 serial port, use the provided RJ-45 to DB-9 serial port adapter.

Replacing a PIM

To remove or install field-replaceable Physical Interface Modules (PIMs) in a Services Router, you must first power off the router. This section contains the following topics:

Removing a PIM on page 120

Installing a PIM on page 122

Removing a PIM

The PIMs are installed in the front of the Services Router. A PIM weighs less than 1 lb (0.5 kg).

120Replacing the Console Port Cable

Page 144
Image 144
Juniper Networks J2350 manual Replacing the Console Port Cable, Replacing a PIM, Removing a PIM, Tools and Parts Required