Juniper Networks J2350 manual Installing a J4350 or J6350 Crypto Accelerator Module

JUNOS Software with Enhanced Services Hardware Guide

Installing a J4350 or J6350 Crypto Accelerator Module

To install a Crypto Accelerator Module:

1.Take the following steps if you have not already done so:

a.Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the router is disconnected from earth ground. For more information about ESD, see “Preventing Electrostatic Discharge Damage” on page 201.

b.Press and release the power button to power off the Services Router. Wait for the POWER LED to turn off.

c.Unplug the power cord or cable from the power source receptacle.

d.Remove the screws from the sides and the top of the chassis, and slide the cover off the chassis.

2.Locate the Crypto Module socket on the system board (see Figure 84 on page 150). The socket is tipped up at an angle when empty.

3.If a screw and standoff washer are already in place (see Figure 85 on page 151), remove them.

4.Remove the Crypto Module from its electrostatic bag and insert it into the socket.

5.Push the Crypto Module down flat against the main board until the release clips click into place, as shown in Figure 86 on page 151.

6.Insert the standoff washer under the Crypto Module.

7.Insert the screw and tighten it until snug. Do not overtighten.

8.Slide the cover onto the router, and replace and tighten the cover screws.

9.Replace the power cord or cable.

10.Press and release the power button to power on the router. Verify that the POWER LED lights steadily.

11.Verify that the Crypto Module is correctly installed by issuing the show chassis hardware command, as shown in the following example:

user@host> show chassis hardware
Hardware inventory:
Item	Version	Part number Serial number	Description
Chassis		JN1086A34ADA	J4350
Midplane	REV 00	710-014594
System IO	REV 00	710-012315	JX350 System IO
Routing Engine	REV 00	710-012149	RE-J4350-2540
Crypto Module			Crypto
acceleration
FPC 0			FPC
PIC 0			4x GE Base PIC

If Crypto Module appears in the output, the Crypto Accelerator Module is installed correctly.

152■ Replacing Crypto Accelerator Modules on J4350 and J6350 Routers