Juniper Networks J2350 manual About the CLI Configuration Wizard

JUNOS Software with Enhanced Services Hardware Guide

Table 42: Set Up Quick Configuration Summary (continued)

Field	Function	Your Action
Allow Telnet Access	Allows remote access to the router using	To enable Telnet access, select the check box.
	Telnet.
Allow JUNOScript	Allows JUNOScript to access the router using	To enable JUNOScript access over clear text, select the
over Clear-Text	a protocol for sending unencrypted text over	check box.
Access	a TCP connection.
Allow SSH Access	Allows remote access to the router using SSH.	To enable SSH access, select the check box.

Configuring Basic Settings Using the CLI Configuration Wizard

To establish basic connectivity on a Services Router, you must identify the router, connect the router to the network, and specify basic network settings. This section explains how to use the command line interface (CLI) configuration wizard for JUNOS software with enhanced services to configure basic settings so that you can connect the router to a network and further configure it using the J-Web interface or the CLI.

NOTE: To use the CLI configuration wizard, you must have JUNOS software with enhanced services installed on your Services Router. If JUNOS software with enhanced services is not installed on your Services Router, following the instructions in“Configuring Basic Settings with J-Web Quick Configuration” on page 103 to use the J-Web Quick Configuration pages to configure basic settings or use the CLI, as described in “Configuring Basic Settings with a Configuration Editor” on page 110.

About the CLI Configuration Wizard

The JUNOS software with enhanced services configuration wizard is a command line interface application that allows you to configure basic settings for a Services Router that is already configured with the factory default settings. For details on factory default settings, see the JUNOS Software Administration Guide.

Understand these configuration wizard characteristics before using the wizard:

■Because the configuration wizard overrides any existing configuration, it is meant to be used on a router configured with the factory defaults only.

■The configuration wizard shows default values in parenthesis ( ).

■At any time during the configuration you can type a question mark (?) to obtain Help.

■To terminate the configuration at any time without completing it, press Ctrl+c.

■After you complete the configuration, the wizard allows you to review it before committing it on the router.

106■ Configuring Basic Settings Using the CLI Configuration Wizard