Juniper Networks manual To replace the cover on the J2320 and J2350 chassis

Chapter 8: Replacing Hardware Components

5.With a Phillips screwdriver remove the flat head screws from the rear and sides of the chassis.

6.Position the router so that you face the front panel.

7.Place your hands on the cover and press down while pushing the cover back until the two front tabs disengage from the chassis base (see

Figure 61 on page 125).

Figure 61: Sliding the Chassis Cover

8.Lift the cover upward and pull it away from the tabs on the rear of the chassis (see Figure 62 on page 125).

Figure 62: Removing and Replacing the Chassis Cover

To replace the cover on the J2320 and J2350 chassis:

1.Lower the cover onto the chassis so that the front edge of the cover is a few inches away from the front edge of the chassis base (see Figure 62 on page 125).

2.Tilt the cover and align the rear tabs with the slots at the bottom of the chassis (see Figure 63 on page 126).

Removing and Replacing the Chassis Cover on J2320 and J2350 Routers ■ 125