Juniper Networks J2350 Dual-Port Channelized T1/E1/ISDN PRI PIM, Status LEDs for T1 and E1 Ports

Chapter 3: PIM Overview

■G.703, G.704, and G.706 E1 standards compliance

■Independent internal and external clocking system

■Loopback, bit error rate test (BERT), T1 facilities data link (FDL), and long buildout diagnostics

For pinouts of cable connectors for T1 and E1 PIMs, see “E1 and T1 RJ-48 Cable

Pinouts” on page 191.

To install or remove a PIM, see “Replacing a PIM” on page 120.

Status LEDs indicate port status. Table 26 on page 49 describes the meaning of the LED states.

Table 26: Status LEDs for T1 and E1 Ports

Color	State	Description
Green	On steadily	Online with no alarms or failures.
Red	On steadily	Active with a local alarm. The router has
		detected a failure.
Unlit	Off	Offline.

For alarms, see the configuring and monitoring alarms information in the JUNOS

Software Administration Guide.

Dual-Port Channelized T1/E1/ISDN PRI PIM

The Dual-Port Channelized T1/E1/ISDN PRI PIM (Figure 31 on page 50) is a multiflex interface card that allows you to configure a single interface as a channelized T1 interface or a channelized E1 interface. You can also configure ISDN PRI services on a channelized T1 or E1 interface. The channelized T1/E1/ISDN PRI interface supports up to 24 DS0 channels on a T1 interface and up to 31 DS0 channels on an E1 interface, in addition to supporting the features of regular (unchannelized) T1 and E1 PIMs. Each interface can be configured as a single clear-channel, fractionalized, or channelized interface.

NOTE: You cannot configure a channelized T1/E1/ISDN PRI interface through a J-Web Quick Configuration page.

Field-Replaceable PIMs ■ 49