Juniper Networks J2350 manual Removing an AC Power Supply from J6350 Routers

JUNOS Software with Enhanced Services Hardware Guide

1.Locate a replacement power cord with the type of plug appropriate for your geographical location (see “AC Power, Connection, and Power Cord Specifications” on page 69).

2.Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the router is disconnected from earth ground. For more information about ESD, see “Preventing Electrostatic Discharge Damage” on page 201.

3.Press and release the power button to power off the router. Wait for the POWER LED to turn off.

NOTE: If the power supply is a redundant power supply in a J6350 Services Router, you can leave the router powered on and power flowing in the other power supply.

4.Unplug the power cord from the power source receptacle.

5.Unplug the power cord from the appliance inlet on the power supply faceplate.

6.Insert the appliance coupler end of the replacement power cord into the appliance inlet on the power supply faceplate.

7.Insert the power cord plug into an AC power source receptacle.

NOTE: Each power supply must be connected to a dedicated AC power feed. For information about connecting to AC power sources, see “Connecting

Power” on page 84.

8.Verify that the power cord does not block access to Services Router components or drape where people might trip on it.

9.Press and release the power button to power on the router. Verify that the POWER LED lights steadily.

Removing an AC Power Supply from J6350 Routers

The power supplies are located at the right rear of the chassis. A power supply weighs 2.4 lb (1.1 kg).

To remove an AC power supply from a J6350 Services Router (see

Figure 77 on page 141):

1.Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the router is disconnected from earth ground. For more information about ESD, see “Preventing Electrostatic Discharge Damage” on page 201.

2.Press and release the power button to power off the Services Router. Wait for the POWER LED to turn off.

140■ Replacing Power System Components