Chapter 6: Establishing Basic Connectivity

Table 45: Configuring Basic Settings (continued)

Task

J-Web Configuration Editor

Define the backup router

In the Backup router section, next to Address, type the IP

to be used when the

address of the backup router—for example, 192.168.2.44.

router is booting or the

 

 

routing protocol processes

 

 

are not running.

 

 

Define the IP address for

1.

In the configuration editor hierarchy, next to Interfaces,

lo0.0.

 

click Configure or Edit.

 

2.

In the Interface table, locate the lo0 row and click Unit.

 

3.

In the Unit table, click 0, and in the Family section

 

 

next to Inet, click Configure or Edit.

 

4.

To delete the existing IP address, click the Discard

 

 

button. Select the Delete Configuration Below This

 

 

Point option button from the next display.

 

5.

Next to Address, click Add new entry.

 

6.

In the Source box, type the address and prefix length

 

 

for the loopback interface—for example,

 

 

172.16.1.24/32.

 

7.

Click OK.

CLI Configuration Editor

Set the address for the backup router. For example:

set backup router 192.168.2.44

1.From the [edit] hierarchy level, enter

edit interfaces

2.Delete the existing IP address:

delete lo0 unit 0 family inet address

3.Set the IP address and prefix length of lo0.0. For example:

set lo0 unit 0 family inet address 172.16.1.24/32

Define the IP address for ge-0/0/0.

1.In the configuration editor hierarchy, next to Interfaces, click Configure or Edit.

2.In the Interface table, locate the ge-0/0/0row and click Unit.

3.In the Unit table, click 0, and in the Family section next to Inet, click Configure or Edit.

4.To delete the existing IP address, click the Discard button. Select the Delete Configuration Below This Point option button from the next display.

5.Next to Address, click Add new entry.

6.In the Source box, type the address and prefix length for the management interface—for example,

192.168.1.1/24.

7.Click OK.

1.Delete the existing IP address:

delete ge-0/0/0 unit 0 family inet address.

2.Set the IP address and prefix length of ge-0/0/0. For example:

set ge-0/0/0 unit 0 family inet address 192.168.1.1/24

Verifying Basic Connectivity and the Configuration

To verify that the Services Router has the settings you configured, perform the following task:

Displaying Basic Connectivity Configurations on page 114

Verifying Basic Connectivity and the Configuration 113

Page 137
Image 137
Juniper Networks J2350 manual Verifying Basic Connectivity and the Configuration