Chapter 12: Safety and Regulatory Compliance Information

Preventing Electrostatic Discharge Damage

Many Services Router hardware components are sensitive to damage from static electricity. Some components can be impaired by voltages as low as 30 V. You can easily generate potentially damaging static voltages whenever you handle plastic or foam packing material or if you move components across plastic or carpets. Observe the following guidelines to minimize the potential for electrostatic discharge (ESD) damage, which can cause intermittent or complete component failures:

Always use an ESD wrist strap or ankle strap, and make sure that it is in direct contact with your skin.

CAUTION: For safety, periodically check the resistance value of the ESD strap. The measurement should be in the range of 1 to 10 Mohms.

When handling any component that is removed from the chassis, make sure the equipment end of your ESD strap is attached to one of the electrostatic discharge points on the chassis, which are shown in Figure 1 on page 8, Figure 2 on page 9 and Figure 13 on page 22.

Avoid contact between the component and your clothing. ESD voltages emitted from clothing can still damage components.

When removing or installing a component, always place it component-side up on an antistatic surface, in an antistatic card rack, or in an electrostatic bag (see Figure 96 on page 201). If you are returning a component, place it in an electrostatic bag before packing it.

Figure 96: Place a Component into an Electrostatic Bag

Electrical Safety Guidelines and Warnings

When working on equipment powered by electricity, follow the guidelines described in the following sections:

General Electrical Safety Guidelines on page 202

AC Power Electrical Safety Guidelines on page 203

DC Power Electrical Safety Guidelines on page 204

Safety Guidelines and Warnings 201

Page 225
Image 225
Juniper Networks J2350 manual Electrical Safety Guidelines and Warnings, Preventing Electrostatic Discharge Damage