Juniper Networks J2350 manual Subnet mask bit length for this interface 1-32

Chapter 6: Establishing Basic Connectivity

Table 43: Basic Configuration Wizard Summary (continued)

Prompt Function Your Action

To allow you to configure the management interfaces, the configuration wizard presents the following information. To configure a specific management interface, enter the number associated with it at the prompt.

Configure the following network interfaces

Identifier...Interface

....1........ge-0/0/0

....2........ge-0/0/1

....3........ge-0/0/2

....4........ge-0/0/3

Would you like to configure any of the above interfaces [yes, no] (yes):

Please enter one or more identifiers of the interfaces separated by comma.

For example, 1, 2

Please select interface identifiers:

For example, if you enter 1, the following text and prompt is displayed:

Configure IP on interface ge-0/0/0

IP address for this interface:

After you enter the IP address, the configuration wizard presents the following prompt:

Subnet mask bit length for this interface [1–32] (32):

After you enter the subnet mask for the interface, the configuration wizard presents the following prompt:

Enter a security zone name to associate this interface to:

Default Gateway

Would you like to configure default gateway? [yes, no] (no):

If you enter y(es), the configuration wizard presents the following prompt:

Defines a default gateway through which to direct packets addressed to networks not explicitly listed in the routing table.

Type a 32-bit IP address, in dotted decimal notation.

Enter IP address for the default gateway:

New User Account

Configuring Basic Settings Using the CLI Configuration Wizard ■ 109