Juniper Networks J2350 manual E3 PIM, Status LEDs for T3 and E3 Ports

JUNOS Software with Enhanced Services Hardware Guide

Figure 33: E3 PIM

The T3 and E3 PIMs provide the following key features:

■Onboard network processor

■Integrated DSU—Eliminates the need for a separate external device

■Subrate and scrambling options with support for major DSU vendors

■Independent internal and external clocking system

■Loopback (payload–supported only on T3 PIM, local, and remote), bit error rate test (BERT), and T3 far-end alarm and control (FEAC) diagnostics

For pinouts of cable connectors for T3 and E3 PIMs, see “E3 and T3 BNC Connector Pinout” on page 194.

To install or remove a PIM, see “Replacing a PIM” on page 120.

Status LEDs indicate port status. Table 28 on page 52 describes the meaning of the LED states.

Table 28: Status LEDs for T3 and E3 Ports

Color	State	Description
Green	On steadily	Online with no alarms or failures.
Red	On steadily	Active with a local alarm. The router has
		detected a failure.
Yellow	On steadily	■ Loopback mode.
		■ T3 (DS3)—Remote endpoint is in red
		alarm failure.
		■ E3—Remote defect indication (RDI).
Unlit	Off	Offline.

For alarms, see the configuring and monitoring alarms information in the JUNOS

Software Administration Guide.

52■ Field-Replaceable PIMs