AI296 Version 9.8x User’s Guide
AI296 Commands: diag-line
9-47
Tip: Press ENTER to execute a command and press ESC to end the diagnostic
session.
CAUTION: If you are connected to AI296 through a serial port, do not monitor the
port with command diag-line. Use command hide to hide and not
monitor the port. Failure to comply with this statement can cause AI296
to become unresponsive.
Command Type
shell
Formats
diag-line
interpret [ a | x ] Toggles the display of decoded packet data on the line
monitor on or off and optionally selects the format of the data
in the data portion of the packet (a or x).
za displays the data in the data portion of the packet in
ASCII/hexadecimal format. Unprintable data
(hexadecimal values 0x00 to 0x20 and 0x7F to 0xFF)
appears as two digit hexadecimal numbers separated by
a space. Printable data appears as printable characters.
This option only applies to data.
zx displays all the data in the data portion of the packet in
hexadecimal format. All data appears as two-digit
hexadecimal numbers separated by a space. This option
only applies to data.
print Prints the range of revealed LCNs for all lines.
CTRL+sPauses the line monitor.
go or CTRL+qReactivates the line monitor after displaying the line monitor
options.
ESC or qQuits monitoring traffic, exits from the line monitor, and
returns to the prompt.
?Displays a list of the options available for line monitoring
diagnostics.
Table 9-2 Line Monitor Mode Options (Continued)
Option Function