AI296 Version 9.8x User’s Guide

Alias and Call Routing Configuration: Protocol Processing Modules

AEPX

Applied Innovation encapsulation extension is similar to AEPN, but adds the ability to transport X.25 interrupt/reset packets and interrupt/reset confirmation packets through TCP.

ASY

This module takes a single argument that specifies the string to be transmitted on the outgoing connection when a call is placed. The string typically contains a modem dial sequence.

Optional Parameters

Echo Causes local echo from an ASY port.

Edit Buffers calls for line editing and sends lines as a whole when ENTER is pressed. Lines can be edited by using BACKSPACE .

BX25NM

The BX.25 network module is used to translate to and from the AEPN module and the BX25S module. Typically, this module is used with the BX25S module. Refer to BX.25 Configuration on page 6-5 for information about configuring BX.25 parameters.

BX25S

The BX.25 session layer module provides the session layer to X.25 that is required for the AMATPS protocol. Typically, this module is used with the BX25NM module. Refer to BX.25 Configuration on page 6-5 for information about configuring BX.25 parameters.

ETER

End to end reset is used on a PVC in the data transfer state to pass reset requests without confirmation. The endpoint is responsible for confirming the reset which is also passed through. This option works only with PVCs and is used on the X.25 side of the connection.

PAD

Packet assembler disassembler works with messages traveling between X.25 and asynchronous protocols. The X.25 protocol does not use break signals, but the asynchronous protocol does. PAD converts X.25 Q-bits into asynchronous breaks, and vice versa.



Note: This protocol processing module can be put on an X.25 data stream.

8-30

Page 234
Image 234
Kentrox AI296 manual Aepx