Kramer Electronics Revision 6 Trigger Types Available, Available Triggers for Room Controllers

Introduction

1.3 Trigger Types Available

Table 3 lists the types of triggers that can be used for each room controller. Section 6 describes K-Config triggers in detail.

Table 3: Available Triggers for Room Controllers

Unit	Device	All Off / All On	Device	Custom (from Web	Buttons	Knob	Scheduler	Monitor	GPI/O
	Startup	(from Site-CTRL)	Inactivity	page or scheduled)		Up / Down		Serial Input
RC-2					
RC-2C					
RC-52							
RC-52N/A							
SV-551					See note 1	See note 1		
SV-552					See note 1	See note 1		
SL-1					See note 1	See note 1			See note 4
RC-6x								
RC-6xL								
SL-14RC/N									See note 4
RC-74DL									See note 4
RC-53D						
RC-53DLC						
RC-54DL						
RC-5B2, RC-5B4					
RC-3TB/U					See note 5
RC-13TC								
WP-500								
WP-501								
VP-31KSI	See note		See note 3
	2
VP-81KSI	See note		See note 3
	2
SL-12					See note 1	See note 1			See note 4
SL-10					See note 1	See note 1			See note 4

Note 1: This command can be available, depending on the auxiliary device connected to the Master room controller

Note 2: In the VP-81KSI, this trigger is activated when the first PC Graphics signal is detected on any one of its 8-input channels

Note 3: In the VP-81KSI, this trigger is activated when there is no active PC Graphics signal on any of its 8-input channels for a user defined period of time

Note 4: Available only if defined as a Master room controller

Note 5: The device mimics the button triggers of SL-14RC

3