Kyocera FS-1010 service manual Removing the heat roller, Removing the heat R bush and heat L bush

(3) Removing the heat roller

WARNING The heat roller is extremely hot immediately after the printer was running. Allow substantial period of time until it cools down.

1.Remove and split the fuser unit (See page 5-20).

2.Remove the heater lamp (See previous page).

3.Press the lamp A holder 1 away from the heat roller. Pull up both heat R bush 2 and heat L bush 3 at the same time.

2

3

1

Figure 5-2-23 Removing the heat R bush and heat L bush

FS-1010

5-24